Installation method of Raymond mill roller

Raymond mill is composed of multiple parts, and the grinding roller is also a part of the grinding mill. The grinding roller plays an important role in the production process of Raymond Mill. The grinding roller and grinding ring are both wearing parts, and they must be replaced after a period of use. If the grinding roller is seriously worn, the fine grinding ability of Raymond mill will be significantly reduced. Here is the installation method of the Raymond mill roller.

Understand the importance of Raymond mill roller

Raymond mill, as advanced flour-making equipment, can efficiently grind wheat, corn, and other grain crops into fine powder through its unique roller grinding system. The grinding roller is the core component of the grinding mill, and its installation quality is directly related to the operating efficiency and grinding effect of the whole machine. Therefore, mastering the correct grinding roller installation method is of great significance to ensure the stable operation of the equipment and extend its service life.

Three steps to install the roller of Raymond mill

1. We need to remove the front and rear doors of the Raymond mill, the protective cover and the V-belt on the left, and the gearbox on the right. Then remove the key screws at both ends of the roller, and remove the pulley and gear.

2. Remove the fixing screws on the roller bearing frame of the Raymond mill and the fixing nuts on the movable bearing frame, and use a wooden board of appropriate thickness and length to reach under the roller, slightly pry up the roller and take out the fast and slow roller bearing frames respectively.

3. Then remove the four inserts of the Raymond mill and lift out the two rollers from the front and rear doors respectively.

In addition, for the operators of the Raymond mill, it is necessary to understand the replacement of the key parts of the Raymond mill. Users should pay special attention to the maintenance of the roller to extend its service life.

How to maintain the roller?

1. Regularly clean the iron filings, dust, and other dirt on the surface to ensure the cleanliness of the roller.

2. The roller and the grinding disc should be well-lubricated to reduce wear and energy consumption. The main shaft and roller bearings should be regularly filled with grease.

3. Regularly check the surface wear of the roller, the gaps, and the stress states of each part to ensure its stable operation. Record the faults that occur in the mill so that they can be discovered and solved in time.

4. The feeding should be uniform, not too much or too little, so as not to block the roller or reduce production. At the same time, prevent metal blocks from entering the machine to avoid damage to the roller and grinding ring.

Summary

The installation of the Raymond mill roller is a delicate and important task, which is directly related to the overall performance and grinding effect of the equipment. As a professional manufacturer of mining grinding equipment, MASCOT is committed to providing customers with high-quality products and comprehensive technical support.